PSA Head & neck/body attachment bolts and connectors
PSA Head & neck/body attachment bolts and connectors
1) The industry standard connector is the M16 bolt (2mm thread pitch also referred to as M16/2, M16-2.0, M16 "coarse", or sometimes just M16 (not M16 fine pitch which is 1.5mm)) and this fits almost all dolls. If it's threaded, it's M16. The length of the bolt may differ slightly between 35-45mm. You can get matching bolts, eye hooks, etc at Lowes/Homedepot/Amazon (in the metric section).
1a) Older Irontech - before the summer of 2019 Irontech used M16/M14 connectors. From that point forward Irontech switched to the standard M16 connector. This is the one example that doesn't fit "If it's threaded it's M16".
3) Upgraded Quick Connector: Also known as push-fit, pop-on. The bolt has M16 thread on the body side and ball-lock on the head for a quick on/off removal. The balls are offset and have a 3mm hex keys to adjust the tension on the ball-springs. These connectors can be upgraded on many models, and are compatible with WM, YL, OR, SE, Siliko, JY, AS, Irontech (newer), Climax, Doll 4Ever, SM, Dollhouse168(2019), 6SE/HR (bodies only).
3a) Some models above have started to move to ball-lock on both head and body. These ball-lock adapters look to be back-ward compatible with the threaded M16 models.
viewtopic.php?f=268&t=107498
4) Quick Connector: 6YE, HR. The connector is fixed to the head with ball-lock on the body side.
https://vimeo.com/378113807
5) Quick Connector: DollHouse168 (2016, 2017, EVO models). These a double groove on the neck portion. However 2019 and classic models use M16.
6) Mixing and matching heads and bodies can be done with custom adapters. Keep in mind skin tone and sizing may differ.
http://dollstudio.org/adapters
Re: PSA Head & neck/body attachment bolts and connectors
-
- Contributing Poster
- Posts: 22
- Joined: Fri Dec 22, 2023 12:45 pm
- Contact:
Re: PSA Head & neck/body attachment bolts and connectors
I ordered a couple 6YE heads and they came with these. Both ends fit my 6YE body, but the smooth "quick connect" end doesn't fit my other torsos or even the 6YE heads. It appears to be the same size as other head adapters I have. I'm guessing it's the protruding ball that won't allow it to fit, but there doesn't appear to be an adjuster. I've considered trying to hammer the ball out of the way, but thought I'd check if anyone has experience with them first.
- Attachments
-
- Adapter.jpg (467.47 KiB) Viewed 71 times