Forum Rules,TOS and Privacy Policy | By visiting this website and viewing the pages within, you accept and agree to be bound by and comply with our Rules Of Conduct, Terms Of Use and Privacy Policy
Superb outcome from the modification! Do you have any details on how you formed the tunnels? Are they smoothbore? Was it the same method as your other thread with the soldering iron?
inglorioushz wrote: ↑Sat Feb 10, 2024 1:58 pm
Superb outcome from the modification! Do you have any details on how you formed the tunnels? Are they smoothbore? Was it the same method as your other thread with the soldering iron?
Hello!
Thanks! My vaginal and anal canals are just simple holes created with a soldering iron or apple drill.
I have to say the results of the pussy modification is truly impressive! Not only you fixed the LHP but think this kind of modification can also fix or at least reduce the gaping pussy effect when her legs are spread wide open.
I am willing to try something similar in the future but first I will exercise this on my old TPE torso.
The one thing that got me confused is how did you attach the new TPE pussy to the doll - if you could describe this part in more detail I'd highly appreciate. I assume you used heat, but how? I mean, how do you melt together the parts on the entire surface, considering that the parts which are towards the vag hole are not easily accessible after the pussy print has been placed over the area you prepared on the doll? I tried looking for this but I could not find this information.
I have to say the results of the pussy modification is truly impressive! Not only you fixed the LHP but think this kind of modification can also fix or at least reduce the gaping pussy effect when her legs are spread wide open.
I am willing to try something similar in the future but first I will exercise this on my old TPE torso.
The one thing that got me confused is how did you attach the new TPE pussy to the doll - if you could describe this part in more detail I'd highly appreciate. I assume you used heat, but how? I mean, how do you melt together the parts on the entire surface, considering that the parts which are towards the vag hole are not easily accessible after the pussy print has been placed over the area you prepared on the doll? I tried looking for this but I could not find this information.
Thanks!
Hi!
Thank you for your reply
The best way that I have found is to heat a thin metal knife with gas burner and slide it in between labia piece and body. You then lower labia to body with red hot knife in between. Both surfaces will melt and you draw hot knife away and pieces make perfect connection. This will be done bit by bit, you can not melt the whole piece at once. And I push pieces together as I draw the knife away. Lots of smoke will be created, get a proper respirator.
Rest well... until the next shot. 
. Personally, I would hit that pretty hard!
