Bolts for neck and rattling
-
- Apprentice
- Posts: 15
- Joined: Fri Mar 22, 2024 11:33 am
- Contact:
Bolts for neck and rattling
- Khaossinua
- Active Member
- Posts: 194
- Joined: Mon Mar 13, 2023 5:34 pm
- Contact:
Re: Bolts for neck and rattling
Re: Bolts for neck and rattling
- MinniMagg
- Senior Member
- Posts: 203
- Joined: Wed Oct 28, 2020 1:03 am
- Location: Automobile Capital of the USA
- Contact:
Re: Bolts for neck and rattling
However, if you look at the design you are sliding a large round ball into the narrow "V" shaped groove of the thread inside the body, or the head, whichever direction you install it.
I personally don't like these connectors because as you said, there is no way to stop them from rattling. Yes it's true that there are screws in there that you could increase the tension, forcing the large round ball bearing into the very small Groove into the threaded portion of the receiver section, such as the doll body.
It was not made to be rigid, just easy to connect.
I use a few of them but I still prefer the old style that are a complete screw in connector. If you are not taking your doll's head off a lot, and the other connector will stop the rattling.
The old fully-fitted connector will also keep the doll's head on the body in case you are having a very vigorous encounter using your doll as a sex doll. There is nothing more disappointing than having the doll's head pop off, before you do!
It's a very interesting innovation, but there is no way to lock the head so that it will not rattle or pop off at the worst possible moment.
-
- Apprentice
- Posts: 15
- Joined: Fri Mar 22, 2024 11:33 am
- Contact: