Video tutorial- Cleaning a fixed vagina silicone doll

gonestill77 · Post by **gonestill77** » Thu Mar 26, 2020 2:38 pm

Hello all,

I did a video tutorial on cleaning after playtime.
There was no way I could post this on youtube without it being taken down, so I put it on pornhub.
You can find it here....

If you watch it and still have questions, ask on this thread and I will answer.

Mods, can this be made a stickie in repair and maintenance?

gonestill77 · Post by **gonestill77** » Mon Apr 06, 2020 8:58 pm

Just letting you guys know the link goes to pornhub, hence the explicit content url.
The video is not explicit. You don't see my cock or anything in this video. Just how to clean your doll after banging her.

scooter_ca · Post by **scooter_ca** » Tue Apr 07, 2020 4:46 pm

Great video gonestill77.
I also use a chamois and highly recommend it.

A full chamois can be bulky and difficult to insert and remove from a semi-dry vagina.
Here is the trick I use.
I cut the chamois into squares and attach a string loop to one corner.
I can then push the chamois square all the way into the vagina leaving the string trailing out,
Then the square can be removed by slowly pulling the string

I have been using a "low water" method for the last 4 years and it works well for me.
I cut 6 chamois squares and attach a string loop to each one.
2 squares are 7cmx7cm and 4 are 5cmx5cm.
Daria remains in the bedroom while I head to the bathroom to prepare the chamois.
2 are wet with soap on them. (7cmx7cm squares).
2 are damp with all the water squeezed out.
2 are dry.

Heading back to the bedroom, I insert and remove the wet soapy squares several times.
I then insert and remove the damp squares several time.
I then insert and remove the dry squares several times.
Each time the square is fully inserted as far as it can and then removed via the string.

The string also comes in handy for hanging the chamois squares up to dry.

I use a dual outlet aquarium pump for drying but your method also works well.

Thanks,
scooter

sallan1 · Post by **sallan1** » Tue Apr 07, 2020 5:10 pm

I don't use a bucket, a towel is fine to absorb the runout. I use a similar flavor injector, but I attached a long piece of aquarium hose to the end and just run the tube up in there and rinse her out, repeat with peroxide. No chamois or towel inserted, just the aquarium pump also with a dual hose till she's dry.

gonestill77 · Post by **gonestill77** » Tue Apr 07, 2020 8:37 pm

Thanks for looking guys!

And, thanks for the feedback.
Attaching an aquarium hose to the flavor injector sounds like a good idea. I may try that.

sallan1 · Post by **sallan1** » Tue Apr 07, 2020 8:52 pm

gonestill77 wrote:Thanks for looking guys!
And, thanks for the feedback.
Attaching an aquarium hose to the flavor injector sounds like a good idea. I may try that.

You can leave the needle on and everything, helps the hose seat better. Suck up the soapy water or peroxide with hose attached and then just run the hose up her, not the needle obviously.

MoviePilot · Post by **MoviePilot** » Mon May 25, 2020 4:20 pm

Awesome clip. Thanks for the upload.

gonestill77 · Post by **gonestill77** » Mon May 25, 2020 5:40 pm

MoviePilot wrote:Awesome clip. Thanks for the upload.

Your welcome!

dollboiwad · Post by **dollboiwad** » Fri May 29, 2020 4:27 pm

I'm an idiot but when you turn on the pump are you using it in deflate or inflate mode? Like is it pushing air in to push the remaining liquid out the sides or is it sucking the liquid out? Again, sorry for my stupidity.

gonestill77 · Post by **gonestill77** » Fri May 29, 2020 4:36 pm

dollboiwad wrote:I'm an idiot but when you turn on the pump are you using it in deflate or inflate mode? Like is it pushing air in to push the remaining liquid out the sides or is it sucking the liquid out? Again, sorry for my stupidity.

It's ok, no worries.

I use it in inflate mode to blow dry the inside.

scobuh · Post by **scobuh** » Fri Jun 19, 2020 4:43 pm

Thanks for taking the time to make this tutorial. I'd been moving her to the bathtub for cleanup. Always seemed awkward and high risk of causing damage with a heavy but fragile TPE doll. Glad to see ideas for an easier way.

gonestill77 · Post by **gonestill77** » Fri Jun 19, 2020 7:12 pm

scobuh wrote:Thanks for taking the time to make this tutorial. I'd been moving her to the bathtub for cleanup. Always seemed awkward and high risk of causing damage with a heavy but fragile TPE doll. Glad to see ideas for an easier way.

Your welcome!

There is always an easier way. Lugging to the bathtub was not gonna work for me so I got most of this stuff before I got my first doll.
Figured out the air pump after I had my doll a year. Before that, used a mini fan and that took too long so I got the idea for an electric airpump.

scobuh · Post by **scobuh** » Fri Jun 19, 2020 9:37 pm

Yeah, the bathtub lugging is brutal. Thanks again for sharing your ideas for an easier way.

Barker123 · Post by **Barker123** » Fri Jul 03, 2020 1:18 pm

Great video
This is one of my worries on cleaning my doll
Once I decide which doll i being into my life

Pussychatte · Post by **Pussychatte** » Mon Jul 13, 2020 8:41 pm

Hey, I got a question about cleaning holes: how much time can you let your lady without cleaning her holes between 2 usages.

Let say I fuck my doll at 1 pm and want to use it a bit later during the day. How much time can I leave her with a dirty hole before washing her ?