Cleaning Black Mold

chewy · Post by **chewy** » Fri May 08, 2020 9:36 pm

Eeeeeew, that’s gross,

They really should use PVC tube and rubber joints for skeleton. That would avoid rust and reduce weight.

dom mic · Post by **dom mic** » Fri May 08, 2020 10:49 pm

Black mold? WOE. I would say, don't have intercourse and anal especially cum inside. When i get my doll, i will do what i do with the real woman who sees me, but i wont do 69 or give oral to a doll, i'll position her, all 4s, butt up, up and down on V and B,as if shes twerking while not moving, always on outside, and what about placing saran plastic thin wrap on her butt and V with added lube only on the plastic wrap as i do this? That should protect the tpe material for many years, maby decades, only need very little washing from time to time, and of course never mold or anything else thats hard to clean.

Mushroom69 · Post by **Mushroom69** » Fri May 08, 2020 11:31 pm

As much as I wish the cheaper and nice feeling TPE would be better in the short term, this is why I am going to spend the extra for silicone. I hate the waste and hassle of products with short life span.

siliconelover · Post by **siliconelover** » Sat May 09, 2020 2:36 am

This has a residual effect. It's a Foaming wash. Two or three pumps is all you need. You don't need to be obsessed with drying after cleaning. 20 years and never an issue with my TPE toys. I use it on all my silicone dolls as well.

This is the one product every doll owner should have.

: KeepItClean75_XL.png (215.21 KiB) Viewed 1922 times

DARKSUN · Post by **DARKSUN** » Sat May 09, 2020 6:45 am

icewind wrote:

Schwarz02.jpg

Oh, the horror!

icewind · Post by **icewind** » Sat May 09, 2020 9:14 am

Yes, that was a doll i received for disposal...

No chance to clean it, because it's deep in the TPE as you can see.

But no smell or change of the surface...

ColColt · Post by **ColColt** » Sat May 09, 2020 2:11 pm

icewind wrote:

Schwarz02.jpg

Damn!! What could have caused this-water entering the neck from a shower perhaps?

HSP_960 · Post by **HSP_960** » Sat May 09, 2020 8:21 pm

Thank you for this post! I will continue to avoid TPE dolls and purchase silicone dolls only.

ColColt · Post by **ColColt** » Sat May 09, 2020 8:37 pm

Rust is one thing-mold a different animal. This is was what I found inside one of mine. I can only surmise is was from a lack of proper drying from a novice. It was my first girl. I had never heard of an aquarium pump and dried her best I knew how. Apparently it wasn't enough.

icewind · Post by **icewind** » Sat May 09, 2020 9:57 pm

ColColt wrote:Damn!! What could have caused this-water entering the neck from a shower perhaps?

No, the vagina was not properly sealed towards the skeleton, the doll was wet from knee joints to back joint...

A cheap one from Rifrano, only sealed with a TPE ball without glue...

ColColt · Post by **ColColt** » Sun May 10, 2020 10:26 am

A cheap one from Rifrano, only sealed with a TPE ball without glue...

I didn't know they were still using that ball but had come up with a different way. That's an open invitation to problems.

HSP_960 · Post by **HSP_960** » Sun May 10, 2020 1:35 pm

siliconelover wrote:This has a residual effect. It's a Foaming wash. Two or three pumps is all you need. You don't need to be obsessed with drying after cleaning. 20 years and never an issue with my TPE toys. I use it on all my silicone dolls as well.

This is the one product every doll owner should have.

KeepItClean75_XL.png

Thanks for the tip. I could not find this product even though I searched on Amazon and Google. Where do you buy it?

ColColt · Post by **ColColt** » Sun May 10, 2020 1:44 pm

I don't know if this is comparable or not. I didn't find it either but got close.

https://www.amazon.com/BOMBEX-Anti-Bact ... B07CLM6H1D

HSP_960 · Post by **HSP_960** » Sun May 10, 2020 2:37 pm

ColColt wrote:I don't know if this is comparable or not. I didn't find it either but got close.

https://www.amazon.com/BOMBEX-Anti-Bact ... B07CLM6H1D

Thanks but the product you suggested is "Currently unavailable" on Amazon and they "don't know when or if this item will be back in stock."

siliconelover · Post by **siliconelover** » Sun May 10, 2020 3:01 pm

HSP_960 wrote:
siliconelover wrote:This has a residual effect. It's a Foaming wash. Two or three pumps is all you need. You don't need to be obsessed with drying after cleaning. 20 years and never an issue with my TPE toys. I use it on all my silicone dolls as well.

This is the one product every doll owner should have.
Thanks for the tip. I could not find this product even though I searched on Amazon and Google. Where do you buy it?

I have been purchasing this product 'Keep It Clean' exclusively from this seller for 20 years now.

Sign up for their email and they will send a 10% OFF coupon code.

https://www.cheaplubes.com/collections/ ... -oz-221-ml