Issues regarding the new spinner skeleton from China.
Posted: Wed May 26, 2021 11:25 pm
Hi Patrick, I assume the Chinese skeleton in my 2021 Silicone Spinner is the same skeleton used in the TPE Spinners made there? The finger wires are very frail indeed, you really ought to pressure them to improve their durability. A heavier wire more resistant to fatigue is in order.
Also, The neck bolt threads into a 1/4 inch nut simply tack welded to the frame. (See attached photos) The nut gave way the first time I attempted to use the new stand I just bought. Fortunately, I was holding her when it snapped off, not hanging for more than a minute. I have to wonder if this is an indication of the quality of welding on the rest of the skeleton?
phillip57
Also, The neck bolt threads into a 1/4 inch nut simply tack welded to the frame. (See attached photos) The nut gave way the first time I attempted to use the new stand I just bought. Fortunately, I was holding her when it snapped off, not hanging for more than a minute. I have to wonder if this is an indication of the quality of welding on the rest of the skeleton?
phillip57