Zelex 175, saggy boobs

teddykan1 · Post by **teddykan1** » Thu Jul 25, 2024 8:16 am

My other Zelex 175cm has saggy boobs, see attached.
She's utterly gorgeous but for the boobs.
I tried to inflate them with a needle and syringe. They pumped up OK but deflated in a week.
I've received advice on injecting RayTech Magic Gel, but that gel is expensive (air is almost free) and I'm not sure how well that would hold up

Post by **KKFun** » Thu Jul 25, 2024 11:58 am

You might need some gels to fill them up as a permanent solution. I have seen some videos on YouTube discussing how to do it.

chacka · Post by **chacka** » Thu Jul 25, 2024 2:49 pm

Some use aloe vera gel, seems to work well, they inject it with a turkey needle thing

huytni · Post by **huytni** » Thu Jul 25, 2024 3:21 pm

I can confirm that using Aloe Vera works very well, I've used it in the past on one of my dolls. I didn't have to glue anything. I was a bit concerned with the gel oozing out of where I injected it (same place as you did) but after a few months, I still had no issues. It was definitely worth it!! Especially since I took the oportunity to make the breasts bigger than they originally were, and it worked wonders!!

JRG · Post by **JRG** » Thu Jul 25, 2024 3:47 pm

If you are losing air, I would look into self sealing gel, something like fix a flat, to seal where it is leaking from. I’m not sure if they make anything like that, but it would be worth the look.

I have used sunburn gel in two separate TPE dolls with great success, but they would also hold air, so no issues with sealing.

If you think she was losing air through the injection site, then I’d say typical gels would work, you would just have to seal the injection site with a little glue.

Pussy69 · Post by **Pussy69** » Thu Jul 25, 2024 5:22 pm

Just make sure you insert the gel through the nipple since it can seal up better inside. Injecting air is for hollow breasts.

teddykan1 · Post by **teddykan1** » Fri Jul 26, 2024 11:10 am

The Zelex team picked me up on this thread. They offered to send me, FREE of charge, a silicone repair kit, see below:

"Silicone A and Silicone B are mixed in a 1:1 ratio. Pour the mixed silicone gel into a syringe and insert the needle into the center of the nipple, tilting the needle upwards at 45 degrees to push the gel in. Attached is a repair video, please check it out: https://drive.google.com/file/......"

They offer this to me even when I'm not the original buyer of this particular doll!

Is this top notch doll fan customer service or not? My commendations to Zelex.

Post by **KKFun** » Fri Jul 26, 2024 12:47 pm

teddykan1 wrote: ↑Fri Jul 26, 2024 11:10 am The Zelex team picked me up on this thread. They offered to send me, FREE of charge, a silicone repair kit, see below:

"Silicone A and Silicone B are mixed in a 1:1 ratio. Pour the mixed silicone gel into a syringe and insert the needle into the center of the nipple, tilting the needle upwards at 45 degrees to push the gel in. Attached is a repair video, please check it out: https://drive.google.com/file/......"

They offer this to me even when I'm not the original buyer of this particular doll!

Is this top notch doll fan customer service or not? My commendations to Zelex.

ZELEX is famous for their customer service, may be you can add your kind comments in the following thread too.
viewtopic.php?t=182226&start=30

It should be an easy fix. I cannot see the video though. Any chance you can upload it somewhere here. Thanks.

newleziel · Post by **newleziel** » Fri Jul 26, 2024 4:34 pm

teddykan1 wrote: ↑Fri Jul 26, 2024 11:10 am The Zelex team picked me up on this thread. They offered to send me, FREE of charge, a silicone repair kit, see below:

"Silicone A and Silicone B are mixed in a 1:1 ratio. Pour the mixed silicone gel into a syringe and insert the needle into the center of the nipple, tilting the needle upwards at 45 degrees to push the gel in. Attached is a repair video, please check it out: https://drive.google.com/file/......"

They offer this to me even when I'm not the original buyer of this particular doll!

Is this top notch doll fan customer service or not? My commendations to Zelex.

That is amazing news!
My respect to Zelexdoll!!
I can see now why there are many fans and loyal customers here! If this continues my third doll definitely will be Zelex!!!

teddykan1 · Post by **teddykan1** » Fri Jul 26, 2024 5:14 pm

KKFun wrote: ↑Fri Jul 26, 2024 12:47 pm
teddykan1 wrote: ↑Fri Jul 26, 2024 11:10 am The Zelex team picked me up on this thread. They offered to send me, FREE of charge, a silicone repair kit, see below:

"Silicone A and Silicone B are mixed in a 1:1 ratio. Pour the mixed silicone gel into a syringe and insert the needle into the center of the nipple, tilting the needle upwards at 45 degrees to push the gel in. Attached is a repair video, please check it out: https://drive.google.com/file/......"

They offer this to me even when I'm not the original buyer of this particular doll!

Is this top notch doll fan customer service or not? My commendations to Zelex.
ZELEX is famous for their customer service, may be you can add your kind comments in the following thread too.
viewtopic.php?t=182226&start=30

It should be an easy fix. I cannot see the video though. Any chance you can upload it somewhere here. Thanks.

The video very simply shows how you mix two equal amounts of silicone compound A and B (using small electronic precision weigh scales), stir, then pour into a syringe capped with a large bore needle. The thick goo is squeezed into the nipple as instructed, but as the goo is thick it takes some time for the stuff to flow in.

I'm now waiting for this repair kit to arrive. Kudos to Zelex. Not only are their dolls so lifelike, their staff is so likable too

teddykan1 · Post by **teddykan1** » Wed Aug 14, 2024 4:46 am

Kudos to Zelex, the silicone gel for repairing the boobs has arrived, free of charge. And a generous quantity too.

I've to get some 1.2mm bore needles to make this work.

Zelex customer service is amazing

manfredixon · Post by **manfredixon** » Wed Aug 14, 2024 11:45 am

This is a very interesting thread, please keep sharing your progress if it's not too much trouble.

I have sort of the opposite "problem". I find that the Zelex 170C has breasts that are a little too large and "bubbly" looking for my taste. I certainly don't mind them, as the 170C is one of my all-time fav bodies, but I have been considering some light breast reduction surgery...

So, does anyone know if you can simply suck a little bit of gel OUT of the breast, with a syringe and thick needle, to make them look a little more natural? I mean, is the gel in a firm or liquid state inside the breast cavity?

Thanks,
Fred

Post by **KKFun** » Wed Aug 14, 2024 3:24 pm

manfredixon wrote: ↑Wed Aug 14, 2024 11:45 am This is a very interesting thread, please keep sharing your progress if it's not too much trouble.

I have sort of the opposite "problem". I find that the Zelex 170C has breasts that are a little too large and "bubbly" looking for my taste. I certainly don't mind them, as the 170C is one of my all-time fav bodies, but I have been considering some light breast reduction surgery...

So, does anyone know if you can simply suck a little bit of gel OUT of the breast, with a syringe and thick needle, to make them look a little more natural? I mean, is the gel in a firm or liquid state inside the breast cavity?

Thanks,
Fred

They are likely in solid form, as the liquid when mixed will dry and stay in solid form.

MattN · Post by **MattN** » Thu Aug 15, 2024 8:46 am

This gave me an idea, they should sell a kit to inject if you want your dolls to have bigger tits, ass. Could be risking irreversible damage though.

The silicon mold should be modular for customizable tits and ass size in my opinion.