The Doll Forum

Hi everybody,

I am interested in a doll but I find that the vaginal lips are at the lowest because in a real woman, looking at the front we can see the vaginal lips; but with the doll that interests me this is not the case.

So I would like to have your opinions / experiences to be able to extend it upwards.

My idea is to heat a rod like a screwdriver and press the TPE to extend the vaginal lips upwards.

Here are 2 photos, one of the original doll and the second is my wish (the red line is the extension of the opening of the vaginal lips)

What do you think is feasible?

Other ideas?

Thank you

Can anyone help me?

I would say "don't do it". Heating up a metal rod and touch the TPE will only create an ugly permanent black burn on the most important part of the doll. It's better to just leave it alone.

Hi maybe use make up to create the impression of the look you require,I dont own a tpe doll but I personally would not attemp the procedure.
MG

thank you, it's a good idea to use make up but in reality it's not enough because I'm a fan of cameltoe and makeup will not do it

Don't you think it is weird?

what is weird about?

could one have a add on instead of moulding existing ? how to permanatly or semipermanatly fasten it ?

here is some inspiration if you did not se it before, an insert :
viewtopic.php?f=6&t=88798&hilit=juicy

Viktor

Sun2k wrote:Hi everybody,

I am interested in a doll but I find that the vaginal lips are at the lowest because in a real woman, looking at the front we can see the vaginal lips; but with the doll that interests me this is not the case.

So I would like to have your opinions / experiences to be able to extend it upwards.

My idea is to heat a rod like a screwdriver and press the TPE to extend the vaginal lips upwards.

Here are 2 photos, one of the original doll and the second is my wish (the red line is the extension of the opening of the vaginal lips)

What do you think is feasible?

Other ideas?

Thank you

I would like to see this too. Did you ever figure out a good solution?

There are several members of TDF who can heat and reshape TPE.
To create more cameltoe, maybe the area could be sliced then reshaped or a "V" section removed and reshaped?

Sun2k,

Be sure if your going to do something,
first test it on an outside of an insert or a piece of TPE.

if not available the back of the head under the wig.

p.s. is the status of your OR156cmB sold ?