Modifying my doll's LHP
- Echo_Chamber
- Senior Member
- Posts: 219
- Joined: Sat Dec 02, 2023 2:21 am
- Contact:
Modifying my doll's LHP
Doll is a LD 167D, USA stock w/ std. TPE.
Upon careful reconsideration of how to proceed with the modification, here are my revised thoughts:
(1) Lift the butt cheeks and the lower tummy by making incisions. This will clear the way for the LH block to be cut.
(2) Along with the clit, cut the four long incisions needed to form the block.
(3) Lift the tummy and cut to release the LH block.
(4) Remove the wedge from the LH Block. Size wedge to fit at far end of block to avoid an air gap.
(5) Weld via iron two, if possible three, sides of LH Block. TPE Paste the remaining.
(6) Trim substrait underneath Tummy to fashion a smooth appearance. Weld back with heat via an iron.
(7) Weld back butt cheeks via iron.
(8) Refashion crotch via TPE Paste, Heat Gun & Sandpaper, etc.
If I were not spooning the doll, I wouldn't bother with the wedge. Hoping that my geometry holds up well.
- Attachments
Re: Modifying my doll's LHP
I'm interested to see how this turns out, please post updates
Check us out today! I guarantee you won't be disappointed
Website:
https://sxdolled.com/
https://sxdolled.com/collections/sex-dolls
E-mail:
info@sxdolled.com
Follow SxDolled On: Instagram | Twitter | Pinterest | Discord